Webasto Thermo Top Start 5 кВт + Multi-Control
Pre-heater Webasto Thermo Top Start 5 kW Minitimer.
It has significantly smaller dimensions than previous models, which allows you to install the heater in modern cars with extremely dense layout of the engine compartment. The engineers managed to reduce not only the overall dimensions, but also to reduce fuel consumption by 30% compared to the Thermo Top C series. Economy, high heating capacity, minimum dimensions and low weight made the Top Evo 5 the flagship among the heaters for cars. Designed for cars with engine capacity from 2 to 4 liters.
Heater supply set:
1 - Replacement heater Thermo Top Start 5 12V petrol 5 kW
2 - Circulation pump U 4847 econ 12V (Ø 18mm)
3 - dosing Pump DP 42 12V (petrol and diesel) with mounting
4 - Set of fittings for connection to the heater 2x900 Ø18mm, two spring clamps Ø25mm 2pcs – 90 deg. x18mm
5 - Pack with connecting fittings. Composition: angle fitting 900 x - 2 PCs, self-clamping clamp Ø25mm - 6 PCs
6 - Pack with connecting fittings. Composition: angle fitting 900 - Ø18x18mm - 1 PC straight fitting Ø18x18 mm - 1 PC self-clamping clamp Ø 25 mm – 6 PCs
7 - liquid Hose L= 2m Øvnutr.= 18 mm, Øvnesh.= 18 mm
8 - pressure plate for liquid pipes, two rubber seals, mounting screw
9 - Package with u4847 econ circulation pump bracket, M6 mortgage nut, M6 bolt, bushing
10 - Pack with exhaust clamps and fasteners
11 - a Package of fasteners
12 - exhaust Pipe D=22, d=25.5, L=1000 mm
13 - Package with remote metallized, heat-resistant rings (red) 2 PCs.
14 - air intake Tube Øvnutr 21.4 mm, L= 400 mm.
15 - Packing of cable ties. 40 PCs
16 - standard Bracket
17 - Pack of connecting fuel pipes
18 - wiring Harness main (sealed)
19 - fuse and relay Holder (in-room)
20 - circulation pump Harness
21 - Pack with elements for power connection of the fan motor of the cabin stove
22 - Package with fuel intake
23 - Fuel tube, black 1,5x5mm, L = 5m.
24 - Package with documentation
Composition of Webasto Thermo Top Start 5 heater.
Webasto Thermo Top Start 5 consists of the following main components:
- Air blower with control unit. Disassembly of the supercharger is not allowed!
- Glow pin / flame sensor
- Temperature sensor and overheating sensor
- Circulation pump
- Dosing pump.
The principle of operation of Webasto Thermo Top Start 5.
Starting the heater is via the signal to switch on from the control. The Thermo Top Evo can only be started by a control unit with a WBus bus or by PC diagnostics Thermo Test. When the heater is started, the supercharger, the circulation pump and the filament pin start to function. Then the metering pump is switched on. The petrol heater is started at maximum load. The diesel heater is started with a minimum load and slowly accelerating, goes to the maximum load. During the start phase, the glow pin controls the formation of the flame. After entering the maximum load mode, the filament pin performs the controlling function of the flame sensor. The heater with reaching a certain temperature (about 80°C) goes into energy-saving partial load mode. If the temperature increases further, the heater is switched off from a certain temperature (about 84°C) in the adjustment pause mode. The Gorenje process is stopped when the signal for shutdown is received, when the limit combustion temperature is reached, when the set operating time is reached, or when an error occurs.
Heater Mode Thermo Top - B Thermo Top - D
5 kW 4 kW 5 kW 4 kW
EU certificate numbers e1*2001/56*2006/119*0258*ahhh!.. e1*72/245*2006/96*5627*ahhh!..
E1 122R-00 0258
E1 10 R-03 5627
The design of the Liquid heater with evaporation burner
Heat output Full load part load 5.0 kW
2.8 kW 4.0 kW
2.8 kW 5.0 kW
2.5 kW 4.0 kW
DIN 51625 Diesel fuel
+/- 10 % Full load Partial load 0.705 l/h
0,395 l/h 0,560 l/h
0.395 l/h 0.620 l/h
0.310 l/h 0.495 l/h
Rated voltage 12 V
Operating voltage range 11 - 16.5 V
Rated power consumption without circulation pump
+/- 10 % (without car fan) Full load Partial load 33 W
15 W 21 W
15 W 33 W
12 W 21 W
Permissible ambient temperature: Heater - operation
- storage Metering pump: - work
- storage Summer fuel Liquid fuel -40 ... +60 °C
-40 ... +120 °C
-40 ... +20 °C
-40 ... +10 °C
-40 ... +90 °C -40 ... +80 °C
-40 ... +120 °C
-40 ... +30 °C
-40 ... +90 °C
Permissible operating pressure of the coolant 2.5 bar
Heat exchanger volume 0,075 l
The minimum amount of coolant 1.50 l
The minimum volumetric flow to coolant 200 l/h
CO2 in exhaust gases (allowable range) 8 - 12.0 % of volume
Heater dimensions without mounting parts (tolerance ± 3 mm) L = length: 218 mm
B = width: 91 mm
H = height: 147 mm without fittings
Weight of device / heater with mounting kit 2.1 kg / 8 kg
Fuel type Petrol
Type of passenger transport
Voltage 12 V
Weight 8 kg
Webasto Thermo Top Start 5 кВт + Multi-Control reviews
Be the first to write a review of this product!